Table of Contents
Advertisement
Values for the following settings are saved in input presets:
•
•
•
•
•
Saving a preset when using a matrix switcher
When using the DTP2 CrossPoint 82 with a matrix switcher, do the following to save a
preset:
1.
2.
3.
Tie Presets
A matrix tie preset is a complete map of all input, logo, and output tie connections that
are saved and stored in global memory slots. Up to 16 presets can be saved to any of the
available memory addresses.
Power Save Modes
The DTP2 CrossPoint 82 can be placed into a standby (low power) mode via SIS
commands (see the
restore the unit to full power mode, enter the appropriate SIS command, press any front
panel button, switch inputs via SIS command, or cycle power to the unit. The following
power save modes are supported:
•
•
•
Reset Modes
The DTP2 CrossPoint 82 switchers have three reset modes (numbered 1,
4, and 5). Use a small screwdriver or stylus to press and hold the recessed Reset
button to advance through the modes. The green Reset LED blinks to indicate each
mode that is enabled (see the Reset Mode Summary table).
NOTE: This Reset button and LED are located in the lower-right corner of the rear
You can also perform resets using the OSD (see
commands (see the commands for
CrossPoint 82 PCS Help file).
Preset name
Film mode detection
Contrast
Brightness
Detail
Switch each input of the matrix to the DTP2 CrossPoint 82.
Configure each input: size, position, detail, brightness, and contrast.
Save the settings to a preset for recall by the control system when that matrix input is
routed to any DTP2 CrossPoint 82 input.
Power Save
Mode 0 — Full power mode
Mode 1 — All non-essential hardware is shut down.
Mode 2 — All non-essential hardware is shut down, but over-TP functionality and
remote power remain enabled.
panel, and are unrelated to the Reset button and LED in the IPCP control panel of the
DTP2 CrossPoint 82 IPCP models.
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • Operation
•
Horizontal image position
•
Vertical image position
•
Horizontal image size (width)
•
Vertical image size (height)
commands on page 69) in order to conserve power. To
Factory Reset
Reset Modes
on page 47), and PCS (see the DTP2
RESET
RESET
on page 44), SIS
47
Advertisement
Table of Contents
