Table of Contents
Advertisement
Command
IP Control Port Commands (continued)
IP Setup (continued)
Set the port timeout
View current port timeout
Set the global port timeout
View global port timeout
View MAC address
Set LAN IP address,
subnet mask, and gateway
address
24
NOTE:
Setting any values with a
Boot2
by
response (when in verbose mode 2 or 3). See
more information.)
View all IP settings
Reboot networking
KEY:
X1)
= On or off, enable or disable
X6$
= Port timeout
X8&
= IP address
X8*
= Gateway address
X8(
= Subnet mask
X9)
= Hardware (MAC) address
X9#
= Subnet mask in CISG commands
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • SIS Configuration and Control
ASCII Command
Response
(Host to Switcher)
(Switcher to Host)
E 0* X6$ TC }
Pti0* X6$]
E 0TC }
X6$]
E 1* X6$ TC }
Pti1* X6$]
E 1TC }
X6$]
E CH }
X9)]
erbose modes 2 and 3:
V
Iph • X9)]
E 1* X8& / X9# * X8* CISG }
Cisg 1* X8& / X9# * X8*]
CISG
command changes the DHCP setting to Off and the
E 1CISG }
X8& / X9# * X8*]
E 2BOOT }
Boot2 ]
0
= DHCP disabled (default)
Time in increments of 10 seconds before the port connections time out.
1
(10 seconds) through
Default =
Format
Leading zeros in each of the four octets are optional in setting values,
and are suppressed in returned values.
nnn.nnn.nnn.nnn (
nnn.nnn.nnn.nnn (
00-05-A6-
Prefix representing subnet mask bits (subnet mask value in CISG
commands).
Default =
255.255.255.0.
Additional Description
Set the amount of time in increments of
10 seconds before the port connection
times out.
View the set connection timeout of the
current connection.
Set the amount of time in increments of
10 seconds on all IP connections to this
device before the port connection times
out.
View the initial timeout setting for new
TCP/IP port connections.
View unit Media Access Code (MAC)
address
Set the IP address to
port (
and the gateway address to
same time.
Verbose mode command description
View the IP address, subnet mask
(prefix), and gateway address for the unit.
Restart the network after IP setting or
DHCP changes.
1
= DHCP enabled
65000
(650,000 seconds)
30
(300 seconds)
nnn.nnn.nnn.nnn
192.168.254.254
(
0.0.0.0
= default)
255.255.255.0
-
-
xx
xx
xx
/24
, which represents the default subnet mask,
X9)
.
X8&
for the LAN
1
/ X9#
), the subnet mask prefix to
X8*
at the
Cisg
response is followed
on page 59 for
= default)
= default)
,
84
Advertisement
Table of Contents
