Table of Contents
Advertisement
TCP/IP Panel
The TCP/IP panel connects PCS to a specific device through Ethernet. To access this panel, click the TCP/IP tab
to the left of the Device Discovery panel (see figure 37,
Figure 37.
TCP/IP Panel
To connect directly to a connected device with a known IP address:
1. In the IP Address/Hostname field of the Target Device panel (
device.
2. If required, enter the device password in the Password field.
NOTES:
•
The factory configured passwords for all accounts on this device have been set to the device serial
number. Passwords are case sensitive.
•
If desired, select the Show Characters checkbox (below the Port field) to display the password
characters.
3. In the Port field (
4. Click the Connect button (
To connect indirectly to a device through a control processor via an AV LAN:
If your DTP2 CrossPoint 82 is connected to an AV LAN, you can connect to it through a control processor such as
an Extron IPCP, as follows:
1. In the IP Address/Hostname field of the
CrossPoint 82 on the AV LAN, as well as the port number and the password (if needed).
2. Select the Enable Indirect Connection checkbox (
3. In the IP Address/Hostname field of the IP Link Control Processor with AV LAN panel (
address of the control processor connected to the AV LAN.
4. Enter the password if required.
), enter the port number of the desired device (the default is 23).
4
). A new device tab opens.
5
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • Configuration Software
).
1
2
Device panel (
Target
2
).
3
), enter the IP address of the desired
), enter the IP address of the DTP2
), enter the IP
4
84
Advertisement
Table of Contents
