Models; Integrated Digital Twisted Pair Extension - Extron electronics DTP2 CrossPoint 82 User Manual

Models

The presentation switchers are available in the following models:
Model
DTP2 CrossPoint 82
DTP2 CrossPoint 82
IPCP SA
DTP2 CrossPoint 82
IPCP MA 70

Integrated Digital Twisted Pair Extension

The DTP2/XTP inputs and DTP2/XTP/HDBT outputs are proprietary signals that are created
within any of the Extron DTP Extender systems and transmitted over a single shielded
twisted pair (STP) cable.
Depending on the range of the transmitting or receiving device, the twisted pair (TP)
inputs and outputs can each travel up to 330 feet (100 meters) without a loss of signal
integrity. They also support IR (output only) and RS-232 insertion, and dedicated universal
asynchronous receivers and transmitters (UARTs).
Shielded twisted pair cabling with solid center conductor sizes of 24 AWG or better is
recommended for optimal performance.
NOTE: Extron XTP DTP 24 shielded twisted pair cable is strongly recommended for
optimal performance.
• Input —The DTP2 CrossPoint 82 can receive signals from a remote DTP or DTP2
transmitter (such as the DTP T USW 333) at a conference table, lectern, or wall. It can
also be integrated into an XTP CrossPoint matrix switcher system.
Output —The DTP2 CrossPoint 82 can transmit to a DTP or DTP2, XTP, or HDBaseT
•
receiver or directly to an HDBaseT enabled display device. It can also be integrated into
an XTP CrossPoint matrix switcher system.
Power over DTP —The DTP2 CrossPoint 82 can send power to selected DTP or
•
DTP2 endpoints over the same shielded CATx cable, streamlining system design and
installation.
DTP transmitters and receivers are available in compact, low-profile enclosures, and in
decorator-style wallplate and floorbox versions to suit the installation requirements of a
specific application.
RS-232 and IR signal insertion
The DTP2 inputs and output support bidirectional Ethernet to RS-232 insertion. Ethernet
insertion allows you to employ Ethernet drivers from either the local controller (IPCP models
only) or an external controller connected on the IP network.
IR output signals can be inserted from a control system and transmitted over the single
shielded CATx cable together with the video and audio, enabling control of a display.
Description
Base model
1U high
Stereo amplifier
model
2U high
70 V mono
amplifier model
2U high
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • Introduction
Inputs Outputs
1 DisplayPort 1 HDMI
5 HDMI 1 DTP2/XTP/HDBT
2 DTP2/XTP 1 HDMI Loop Out
1 DisplayPort 1 HDMI
5 HDMI 1 DTP2/XTP/HDBT
2 DTP2/XTP 1 HDMI Loop Out
1 DisplayPort 1 HDMI
5 HDMI 1 DTP2/XTP/HDBT
2 DTP2/XTP 1 HDMI Loop Out
2