Table of Contents
Advertisement
For source devices that require encryption, enable HDCP Authorized. If HDCP
Authorized is disabled for sources that require encryption (for example, a Blu-ray player),
the output is muted or a warning message is displayed. Some source devices may
encrypt their output even if the source material does not require HDCP encryption,
preventing content from being displayed on a non-HDCP compliant display. Disable
HDCP Authorized to allow the output of the switcher to remain unencrypted.
NOTE: HDCP Authorized is permanently enabled on DisplayPort Input 1.
•
INn: EDID — Press the navigation buttons to select an EDID for the active input.
Select a discrete EDID from a list of factory-supplied EDID or select Auto to use the
current output resolution and refresh rate. The
next page lists the available EDID selections, including their SIS command variable
numbers (see the commands for
commands).
•
Capture EDID — Select this item to capture the EDID of the sink device attached to
an output and save it to one of the 10 custom EDID slots. The DTP2 CrossPoint 82
assigns the captured EDID to its selected input. To capture an EDID:
1.
Select
Capture EDID
displayed at the top of the OSD screen.
NOTES:
•
If no EDID has been captured yet, the names displayed for the slots are the
default: 1080p @ 60 Hz.
•
If an EDID has been applied to a slot, last three letters of the EDID file
name (in parentheses) represent the name of the display manufacturer (for
example, EXN is an abbreviation of Extron).
Select Slot to Capture Out 2 EDID: 3840x2160 @ 59.95 Hz (DEL)
C1:
C1:3840x2160 @ 59.95 Hz (DEL)
C2:
C2:1920x1080 @ 60 Hz (EXN)
C3:
C3:1920x1080 @ 60 Hz (EXN)
C4:
C4:1920x1080 @ 60 Hz (EXN)
C5:
C5:1920x1080 @ 60 Hz (EXN)
C6:
C5:1920x1080 @ 60 Hz (EXN)
C7:
C5:1920x1080 @ 60 Hz (EXN)
C8:
C5:1920x1080 @ 60 Hz (EXN)
C9:
C5:1920x1080 @ 60 Hz (EXN)
C10: C5:1920x1080 @ 60 Hz (EXN)
Figure 23.
Custom EDID Slots List Example
2.
Press the
or
save the current display EDID.
ƒ
„
3.
Press the
or
captured. In figure 23, output 2 (DTP2) was selected and appears in the top panel.
4.
Press
. The display EDID is saved to the selected custom slot and assigned
Enter
to the connected inputs.
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • Operation
Input EDID Resolutions table
Input EDID
on page 65 for information on the SIS
, then press
. A list of the 10 custom EDID slots is
Enter
button to move the highlighting to the slot to which you want to
button to display the output to which the select EDID will be
on the
35
Advertisement
Table of Contents
