Extron electronics DTP2 CrossPoint 82 User Manual page 91

Command
Information Requests (continued)
View internal temperature
Set verbose mode
View verbose mode
KEY:
X1@
= Internal temperature
X3$
= Verbose mode (see the
command description on page 59 for
more information)
IP Control Port Commands
IP Setup
NOTES:
• Changes made to any TCP/IP settings do not take effect until the reboot network command (
• The following IP address setup commands that are followed by
issue them without Administrator status result in an
Set DHCP mode 24
View DHCP mode
Set IP address
24
Read IP address
Set subnet mask
24
View subnet mask
Set gateway IP address
24
View gateway IP address
KEY:
X1)
= On or off, enable or disable
X8&
= IP address
X8*
= Gateway address
X8(
= Subnet mask
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • SIS Configuration and Control
ASCII Command Response
(Host to Switcher) (Switcher to Host)
E 20STAT } X1@]
Verbose modes 2 and 3:
20Stat• X1@ ]
EX3$ CV } Vrb X3$]
E CV }
X3$]
In degrees Celsius. Response is two digits, padded with a zero.
0
Verbose mode = None (default for LAN connection)
1
= Verbose mode (default for RS-232 and USB connection)
2
= Tagged responses to queries
3
= Verbose mode and tagged responses
E24
E X1) DH } Idh X1)]
E DH } X1)]
E X8& CI } Ipi • X8&]
E CI } X8&]
E X8( CS } Ips • X8(]
E CS } X8(]
E X8* CG } Ipg • X8*]
E CG } X8*]
0
= DHCP disabled (default)
Format
Leading zeros in each of the four octets are optional in setting values,
and are suppressed in returned values.
nnn.nnn.nnn.nnn (
nnn.nnn.nnn.nnn (
Additional Description
View unit internal temperature
degrees Celsius.
Set the verbose mode to
or disable tagged responses (additional
information provided in response to a
query).
View the current verbose mode.
24
require Administrator permission to enter. Attempts to
(privilege violation) error message.
Enable or disable DHCP.
View the DHCP mode setting.
Set the IP address to
View the current IP address.
Set the subnet mask to
View the subnet mask setting.
Set the gateway IP address to
View the gateway IP address setting.
1
= DHCP enabled
nnn.nnn.nnn.nnn 192.168.254.254
(
0.0.0.0
= default)
255.255.255.0
X1@
in
X3$
and enable
E 2BOOT }
) is issued.
X8&
.
X8(
.
X8*
.
= default)
= default)
83