Communications Submenu - Extron electronics DTP2 CrossPoint 82 User Manual

Communications Submenu

Figure 29.
The Communications submenu enables you to view the serial port baud rate and the unit
media access control (MAC) address, and to configure the IP address, subnet mask, and
gateway address, and DHCP mode.
• Serial Port Baud Rate — Displays the baud rate for the Remote RS-232 serial port
(view only). The default is 9600.
MAC Address — Displays the MAC address of the device (view only).
•
• DHCP Mode — When this mode is enabled (
other network settings from the DHCP server. The default is
To enable or disable DHCP mode:
1. Highlight
2.
Press the
You can also set the DHCP mode via an SIS commands (see
page 83), the PCS software, or the internal web page (see
on page 112).
• IP Address — Press the
Press the
192.168.254.254.
• Subnet Mask — Press the
address. Press the
default is 255.255.255.0.
• Gateway — Press the
Press the
0.0.0.0.
Communications Submenu
on the Communications submenu and press
DHCP Mode
>
<
or button to select
and buttons to select an octet of the IP address.
 u
>
<
and buttons to adjust the value of the selected octet. The default is
and
 u
>
<
and buttons to adjust the value of the selected octet. The
and buttons to select an octet of the gateway address.
 u
>
and < buttons to adjust the value of the selected octet. The default is
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • Operation
), the unit obtains an IP address and
On
.
Off
or , and press
On Off Enter
Set DHCP mode
Network Settings Panel
buttons to select an octet of the subnet mask
.
Enter
again.
on
45