Table of Contents
Advertisement
AC power connector — Connect a standard IEC power cord (provided) from a
A
100 to 240 VAC, 50-60 Hz power source to this connector (see
on the previous page).
DisplayPort input connector (input 1) — Connect a DisplayPort source to this
B
female DP connector.
HDMI (with CEC) Loop Out connector — Connect a monitor to this buffered loop
C
out connector. This output can be tied to any input via SIS (see
Control
starting on page 53) or PCS (see the DTP2 CrossPoint 82 Help File within
the DTP2 CrossPoint 82 module of PCS).
DTP2/XTP input connectors (inputs 7 and 8) — Connect one or two DTP
D
transmitters to the DTP2/XTP RJ-45 input connectors 7 and 8. These connectors also
allow for remote powering of DTP and DTP2 transmitters.
You can configure the TP inputs for DTP or XTP mode via SIS commands (see the
Twisted Pair Protocol commands
Submenu
on page 34), or PCS (see the DTP2 CrossPoint 82 Help File within the
DTP2 CrossPoint 82 module of PCS). For cable wiring and recommendations, see
Twisted Pair Recommendations for DTP, XTP, and HDBT Communication
page 23.
ATTENTION:
•
Do not connect these connectors to a computer or telecommunications
network.
•
Ne connectez pas ces ports à des données informatiques ou à un réseau de
télécommunications.
•
DTP2 remote power is intended for indoor use only. No part of the network that
uses DTP2 remote power should be routed outdoors.
•
L'alimentation DTP2 à distance est exclusivement réservée à un usage en
intérieur. Un réseau utilisant une alimentation à distance ne peut pas être routé
en extérieur.
The connectors for inputs 7 and 8 correspond to the following front panel LEDs:
•
Signal (Sig) LED — Lights when the switcher is receiving an active video signal
from a DTP2 transmitter or XTP matrix switcher.
•
Link LED — Lights when a valid link is established to a transmitter device.
HDMI/CEC output connector with CEC (output 1) — Connect an HDMI or DVI (with
E
an appropriate adapter) output device to this HDMI output connector for HDMI video
with embedded audio. This output is not scaled. Output 1 can display the same input
as the DTP2/XTP/HDBT output 2, or a different input.
Use Extron HDMI LockIt Lacing Brackets to secure HDMI cables to the device
TIP:
(see
HDMI Connections
Consumer Electronics Control (CEC) — CEC control commands control basic
control functions such as power on and off, input switching, volume, and mute. The
DTP2 CrossPoint 82 can issue CEC commands to a display device through the HDMI
and DTP2 ports.
Scaled DTP2/XTP/HDBT output connector (output 2) — Allows for remote
F
powering of DTP or DTP2 receivers as well as over-DTP analog audio that matches the
5-pole analog audio output of the display (see
output can display the same input as HDMI output 1, or a different input.
NOTE: In XTP and HDBaseT modes remote power and over DTP analog audio are
not available.
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • Installation
on page 80), the on-screen display (see
on page 21).
figures 3 through 5
figures 3 through 5
SIS Configuration and
Input
on
on page 14). This
15
Advertisement
Table of Contents
