TCP/IP Panel
The TCP/IP panel connects PCS to a specific device through Ethernet.
Figure 43.
1.
Click the TCP/IP tab (see figure 43,
2.
In the IP Address field (
3.
If required, enter the device password in the Password field (
Characters checkbox (see
NOTES:
•
•
4.
In the Telnet Port field (
5.
Click the Connect button (
TCP/IP Panel
), enter the IP address of the desired device.
2
) to display the password characters.
5
The factory-configured passwords for all accounts on this device are initially set
to the device serial number. Passwords are case-sensitive.
Performing a unit factory reset (entering an
a
mode 5 reset
on page 34 via the rear panel Reset button) removes the
serial number passwords, leaving the unit with no password.
), enter the Telnet port of the desired device.
4
). A new device tab opens.
6
DXP HD 4K PLUS Series • Configuration Software
).
1
3
E
ZQQQ } SIS command
). Select the Show
or
84