Keysight Technologies 8163A/B Programming Manual page 98

4 Measurement Operations & Settings
example: sens1:func:par:logg?
affects: All power meters and return loss modules
dual sensors: Can only be sent to master channel, slave channel parameters are identical.
NOTE
command: :SENSe[n][:CHANnel[m]]:FUNCtion:PARameter:MINMax
syntax: :SENSe[n][:CHANnel[m]]:FUNCtion:PARameter:MINMax<wsp>
CONTinous|WINDow|REFResh,<data points>
description: Sets the MinMax mode and the number of data points for the
MinMax data acquisition function.
parameters: CONTinous:
WINDow:
REFResh:
Data Points is the number of samples that are recorded in the memory buffer used by the WINDow and REFResh modes. Data
Points is an integer value.
See Chapter 3 of the 8163A/B Lightwave Multimeter, 8164A/B Lightwave Measurement System, & 8166A/B Lightwave
Multichannel System User's Guide, for more information on MinMax mode.
See
acquisition function.
See
data acquisition function.
See
response: none
example: sens1:func:par:minm WIND,10
affects: All power meters and return loss modules
dual sensors: Can only be sent to master channel, slave channel is also affected.
98
->
+64,+1.00000000E-001<END>
Setting parameters for the MinMax function sets some parameters, including
hidden parameters, for the stability and logging functions and vice versa. You
must use the
:SENSe[n][:CHANnel[m]]:FUNCtion:PARameter:MINMax
command to set parameters before you start a MinMax function using the
:SENSe[n][:CHANnel[m]]:FUNCtion:STATe
:SENSe[n][:CHANnel[m]]:FUNCtion:STATe
:SENSe[n][:CHANnel[m]]:FUNCtion:RESult?
Table 8
on page -208 for information on how triggering affects data acquisition functions.
on page 104 command.
continuous MinMax mode
window MinMax mode
refresh MinMax mode
on page 104 for information on starting/stopping a data
on page 100 for information on accessing the results of a
8163A/B, 8164A/B & 8166A/B Mainframes Programming Guide
on page 98