Keysight Technologies 8163A/B Programming Manual page 86

4 Measurement Operations & Settings
Measurement Functions – The SENSe Subsystem
Keysight 81635A and Keysight 81619A - Master and Slave Channels
86
The SENSe subsystem lets you control measurement parameters for a
Power Sensor, an Optical Head Interface module, or a return loss module.
For the Keysight 81635A Dual Power Sensor and Keysight 81619A Dual
Optical Head Interface module, channel 1 is the master channel and
channel 2 is the slave channel. The master and slave channels share the
same software and hardware triggering system. For some commands,
setting parameters for the master channel sets the parameters for the
slave channel. In these cases, you may only set parameters for the slave
channel by setting master channel parameters.
The commands listed in
channel.
Table 5 Commands that can only be configured using the master channel
Command
:INITiate[n]:[CHANnel[m]][:IMMediate]
:INITiate[n]:[CHANnel[m]]:CONTinuous/?
:READ[n][:CHANnel[m]][:SCALar]:POWer[:DC]?
:SENSe[n]:[CHANnel[m]]:CORRection:COLLect:ZERO
:SENSe[n][:CHANnel[m]]:FUNCtion:PARameter:LOGGing/?
:SENSe[n][:CHANnel[m]]:FUNCtion:PARameter:MINMax/?
:SENSe[n][:CHANnel[m]]:FUNCtion:PARameter:STABility/?
:SENSe[n][:CHANnel[m]]:FUNCtion:STATe/?
:SENSe[n]:[CHANnel[m]]:POWer:ATIME/?
:SENSe[n]:[CHANnel[m]]:POWer:RANGe:AUTO/?
:TRIGger[n][:CHANnel[m]]:INPut/?
:TRIGger[n][:CHANnel[m]]:INPut:REARm/?
:TRIGger[n][:CHANnel[m]]:OUTPut/?
:TRIGger[n][:CHANnel[m]]:OUTPut:REARm/?
Table 6 can only be configured using the master
8163A/B, 8164A/B & 8166A/B Mainframes Programming Guide
Page
page 89
page 91
page 92
page 94
page 97
page 98
page 99
page 104
page 105
page 109
page 210
page 211
page 213
page 214