Keysight Technologies 8163A/B Programming Manual page 226

5 Mass Storage, Display, and Print Functions
command: :DISPlay:ENABle
syntax: :DISPlay:ENABle<wsp>ON|OFF|1|0
description: Enables or disables the display.
The display is cleared, and an appropriate message displayed. This setting may improve sweep performance.
parameters: A boolean value:
If you press [L
response: none
example: disp:enab 1
command: :DISPlay:ENABle?
syntax: :DISPlay:ENABle?
description: Queries the state of the display.
parameters: none
response: A boolean value:
example: disp:enab?
command: :DISPlay:LOCKout
syntax: :DISPlay:LOCKout<wsp>ON|OFF|1|0
description: Enables or Disables local operation.
226
:DISPlay:ENABle
OFF or boolean 0 – switch off the display
ON or boolean 1 – switch on the display
] softkey, the display is enabled automatically.
OCAL
:DISPlay:ENABle?
0 – the display is turned off
1 – the display is turned on
->
1<END>
:DISPlay:LOCKout
8163A/B, 8164A/B & 8166A/B Mainframes Programming Guide