Extended Trigger Configuration - Keysight Technologies 8163A/B Programming Manual

Extended Trigger Configuration

command: :TRIGger
syntax: :TRIGger<wsp>NODEA|1|NODEB|2
description: Generates a hardware trigger.
parameters: 1 or NODEA:
2 or NODEB:
Use
:TRIGger
response: none
example: trig 1
command: :TRIGger:CONF:EXTended
syntax: :TRIGger:CONF:EXTended<wsp><Node A Input Config.>,
<Node B Input Config.>,<Output Matrix Config.>
description: Sets the extended hard ware trigger configuration.
parameters: Node A Input Configuration:
Node B Input Configuration:
Output Matrix Configuration:
response: none
example: trig:conf:ext 0,0,0
command: :TRIGger:CONF:EXTended?
syntax: :TRIGger:CONF:EXTended?
description: Returns the extended hardware trigger configuration.
8163A/B, 8164A/B & 8166A/B Mainframes Programming Guide
This section includes information for advanced users about how to
customize your use of the trigger system.
You can configure the ouputs and inputs from two nodes, Node A and
Node B. See <Cross Reference Color>Figure 7on page 219 for more
information on Node A and Node B. You can configure these nodes to be
triggered by certain events and for these nodes to trigger particular
actions.
:TRIGger:CONF:EXTended
on page 209 describes the :TRIGger command for basic users.
Generates trigger at Node A.
Generates trigger at Node B.
on page 217 to configure Node A and Node B.
A 32-bit unsigned integer, see below.
A 32-bit unsigned integer, see below.
A 32-bit unsigned integer, see below.
Measurement Operations & Settings 4
217