Diagnosis With Tool Change Configuration - Festo CPV-D102 Elektronics Manual

3. Diagnosis CPV−DI02 (PROFIBUS−DP)

3.2.5 Diagnosis with tool change configuration

Value Fault type (standard)
... ...
... ...
... ...
Tab. 3/17: Diagnosis with tool change configuration
Festo P.BE−CPV−DI02−E N en 0704NH
In the tool change configuration only a simple diagnostic
message is output for the CP string via the channel−related
diagnosis. (Information on the tool change configuration
see section 2.3.4.)
Note
In the tool change configuration the diagnostic information
for all modules in the CP string is entered in the 2nd. diag
nostic byte. No information is given as to which module
registers the fault. Note the module LEDs in the CP string
for ascertaining the exact location of the fault.
Value
...
18
...
The diagnostic information of the CPv−DI01 basic device is
normally entered in the 1st. diagnostic byte in the tool change
configuration.
Fault type (Festo)
...
Periphery fault in the tool change
configuration
...
3−19