Festo CPV-D102 Elektronics Manual page 73

2. Commissioning CPV−DI02 (PROFIBUS−DP)
Basic configuration
Modifying the address
Festo P.BE−CPV−DI02−EN en 0704NH
The CPV−DI02 valve terminal always occupies 16 output
addresses. Carry out first a configuration of the basic device
as follows.
3. Pull the entry Base: 16DO" onto the 1st. line of the
configuration table 4 .
4. Pull the modules onto the next free line in the configur
ation table according to the extension of your CPV Direct.
Assign the starting address in the window Properties
DP slave" 5 .
Note
Pull the modules into the configuration table according
to the physical sequence of the extensions of your CPI
system.
The addresses are assigned automatically.
Double click on the relevant line in the configuration
·
table and modify the starting address of the
inputs/outputs in the window Properties DP slave".
Note
With S7−400 controllers, up to 4 bytes of addresses are
reserved for each DP identifier, depending on the version
status.
This concludes the station selection and configuration.
2−15