3. Diagnosis CPV−DI02 (PROFIBUS−DP)
3.5
Short circuit/overload
3.5.1 Output module
3−26
Detailed information on input and output modules can be
found in the manual CP modules electronics" and CPI−CL
modules, CPI−EL modules."
If there is a short circuit or overload
all the digital outputs of an output module will be
switched off
if it exists, the diagnostic LED on the output module will
light up, otherwise the green LED will flash
the bit Short circuit/overload in octet 9 Device−related
diagnosis 2", will be set to logical 1.
Note
The outputs cannot be used again until the short circuit or
overload has been eliminated and the fault deleted.
Festo P.BE−CPV−DI02−E N en 0704NH