Setting The Diagnostic Mode - Festo CPV-D102 Elektronics Manual

5. Diagnosis CPV−CS02 (ABB CS31)
5.3

Setting the diagnostic mode

Festo P.BE−CPV−DI02−E N en 0704NH
The following fault messages can be switched off with
element 8 of the DIL switch in the switch module
(see section 1.2.3):
Load voltage failure of the CPV Direct or the CP valve
terminals/CPI output modules in the CP extension string.
Failure of the additional supply for the CPI input modules
in the CP extension string.
The following table shows the reaction of the diagnostic LEDs
or fault flags with active/inactive load voltage monitoring:
Monitoring active
LED BF lights up
LED PL
flashes
Fault flag set
1)
Only with load voltage faults on the CPV Direct
Tab. 5/8: Setting the diagnostic mode reaction of LEDs
and fault flags
Monitoring inactive
off
1)
flashes
reset
1)
5−11