Reaction Of The Cpi System To Faults In Operation; Eliminating Assignment Faults - Festo CPV-D102 Elektronics Manual

1. Installation CPV−DI02 and CPV−CS02
1.9

Reaction of the CPI system to faults in operation

1.9.1 Eliminating assignment faults

1−42
Warning
Undesired activation of actuators
An incorrect status of the valves and outputs can lead to
dangerous situations.
Make sure that valves and outputs are put into a safe
·
state when faults occur.
If there is a fault on the CP string during operation, e.g. due
to cable fracture, etc., this will be displayed on the CPV Direct
by the diagnostic LED of the string extension (P). The status
LED on the relevant module goes out. All modules working
without faults remain ready to operate.
Detailed instructions on diagnosing the CPV Direct using the
LEDs can be found in section 3.1.
In order to eliminate assignment or connection faults of the
CPI system:
1. Switch off the power supply for the CPV Direct.
2. Restore the saved assignment by connecting the
appropriate CPI/CP modules with the CPV Direct.
3. Switch on the power supply for the CPV Direct again.
Festo P.BE−CPV−DI02−EN en 0704NH