Replacing Cables - Sirona ORTHOPHOS XG 3Dready Service Manual

Tab 6
59 38 399 D3352
D3352.076.01.26.02 09.2016
6.23

Replacing cables

CAUTION
Switch the unit OFF before you start replacing cables or
removing connectors.
CAUTION
Be careful not to twist the cables or kink the fiber-optic light guides when in-
stalling them.
i
NOTE
An overview of all cables can be found in section 1.11.
Always check the cables before replacing them
(see section 3-18).
The cables are labeled with small flags.
They specify the designation and part number of the cable.
The plugs and sockets on the cables are designated both on the boards and
cables.
Check the designations of the cables when pulling them off.
Some of the cables are marked with green adhesive tape. Mark the corre-
sponding positions on the unit before removing an old cable. Lay the new ca-
ble so that the cable markings again come to rest at the corresponding posi-
tions marked on the unit while removing the old cable.

6.23 Replacing cables

6 – 101