Laying Cable L1 And The Grounding Strap (In Cable Track 1) - Sirona ORTHOPHOS XG 3Dready Service Manual

6.23 Replacing cables
6.
Drawing new cables into the cable track
Reinstalling the cable track in the unit
6 – 108
7.
*) as of unit hardware version
With defective cable L8/L108*:
Wrap the connector X303 of the new cable L8/L108* with adhesive tape to
protect the detent against breaking off.
Lay the cable track down on a flat surface stretched out.
6. Fasten the two (new) cables together with adhesive tape above the flag la-
bels.
7. Push both cables (together) into the cable track up to the cable markings.
CAUTION
Push the green cable. The white cable is carried along. In this way, you can
prevent the sensitive fiber-optic cable from being damaged.
i
NOTE
New cables have no cable markings. Orientate yourself according to the mark-
ing on the second (old) cable and make sure that both cables protrude equally
far out of the cable track once they have been drawn in. Then make a mark on
the new cable.
8. Before installing the cable track in the stand, fasten the cables to both
ends of the cable track using cable ties.
CAUTION
The cable ties should only fix the position of the cables. They must not be fas-
tened too tightly, as overtightening them could damage fiber-optic cable L7.
The actual installation of the cable track is performed in the reverse order
of its removal.
6.23.4 Laying cable L1 and the grounding strap
(in cable track 1)
The procedure for replacing cable L1 and the grounding strap is basically
analogous to the procedure described in chapter 6.23.3.
8.
D3352.076.01.26.02 09.2016
Tab 6
59 38 399 D3352