Replacing Circuit Boards; Important Notes About Replacing Boards - Sirona ORTHOPHOS XG 3Dready Service Manual

Tab 6
59 38 399 D3352
D3352.076.01.26.02 09.2016
6.22

Replacing circuit boards

6.22.1

Important notes about replacing boards

CAUTION
Please observe the usual precautionary measures for handling
Printed circuit boards (ESD).Touch a ground point to discharge
static electricity before touching any boards.
CAUTION
Replacement of printed circuit boards DX6 and DX11:
Never replace both boards at the same time. After replacing one of these
boards, first proceed as specified in section 6.22.4 and then restart the unit.
Only then may you begin replacement of the other module.
CAUTION
Prior to circuit board replacement:
Open the and
PAN CEPH RESET ADJUSTMENT
down the adjustment values before you start replacing the boards.
CAUTION
Replacement of circuit board DX11:
– If the old DX11 is still working:
Open the ; look for
DETAILS
the "Language Set ID" (listed in "Extended Configuration DX7") and
write down the configuration of the Language Set Index.
If it differs from 00
the Language Set Index has to be resetafter inserting a new
DX11, using the service routine S017.5
(see page 5-93).
– The replacement of circuit board DX11 also causes the loss of user
preference settings (patient symbols, quickshot pre-selections etc.). Point
this out
to the user or set the original values up again after the replacement
of the circuit board, provided they could still be queried prior to
the replacement.
CAUTION
Please be sure to read the notes in Section "6.22.4 Measures following re-
placement of boards " (see page 6-77)!
This Service Manual describes all measures required after the replacement of
modules or circuit boards, provided they were known at the time of publication.
You will find more up-to-date information and supplements concerning this
subject on the latest ORTHOPHOS XG CD and on the Sirona dealer page on
the Internet. For this reason, you should always check for the latest informa-
tion on the replacement of modules and performing updates before you start
replacing any modules or boards.

6.22 Replacing circuit boards

menus in SIDEXIS and write
6 – 73