Density Adjustment Mode - Canon imagePRESS C1+ Reference Manual

Details of each item are shown below.
0: This is the default value. Exposure recalibration is not made when scanning
originals.
1 to 5: Exposure recalibrations are made when scanning originals. Increase the value to
increase the exposure recalibration level.
NOTE
You can set the value for <Left Edge> and <Right Edge> separately. For example, if you want to
perform a full-scale recalibration for the left edge, but only a slight calibration for the right edge,
set '5' for <Left Edge> and '1' for <Right Edge>.
3
Press [OK].

Density Adjustment Mode

This mode enables you to change the method to control the amount of toner.
■ A Mode
This is the default setting. The amount of toner is restricted in this mode, and settings made for colour
adjustments, such as Color Balance, may not be reflected to prevent the toner on the paper from
scattering and image blurring on high density areas.
■ B Mode
This mode removes all toner restrictions. Settings made for colour adjustments, such as Color Balance,
are directly reflected.
CAUTION
Make sure to contact your local authorized Canon dealer before changing the Density
Adjustment mode. Depending on the environmental conditions and the paper type, an
excessive amount of toner may cause paper to curl around the fixing unit. This may cause
damage to the fixing unit, and require the fixing unit to be repaired.
IMPORTANT
[Density Adjustment Mode] is displayed only if the settings are made available by your local authorized
Canon dealer. Even if [Density Adjustment Mode] is displayed, do not allow anyone to change the
settings except for the system manager. For more information on changing the settings, contact your
local authorized Canon dealer.
Device Management Settings
6
6-93