Canon imagePRESS C1+ Reference Manual page 453

IMPORTANT
• Do not load paper into the paper deck that has been previously copied onto, as this may result in
a malfunction or damage to the copier. Always use the stack bypass to feed paper when you
want to copy onto the back of a sheet of paper that already has something copied on its front
side (2nd side of 2-Sided copy).
• Make sure that the size change plate is properly aligned with the marks of the desired paper size.
If the size change plate is not properly aligned, the paper deck may become damaged.
• Paper which has been rolled or curled must be straightened out before loading it into the paper
deck.
• Make sure that the height of the paper stack does not exceed the loading limit mark (
inside of the paper deck.
NOTE
• The paper deck holds approximately 3,500 sheets of paper (80 g/m
• Load the paper stack in stages, adding approximately 550 sheets of paper (80 g/m
the paper deck can accommodate more paper, the lifter will descend.
• Only load 330 mm x 483 mm, 320 mm x 450 mm (SRA3), 305 mm x 457 mm, A3, and A4 paper
into the Paper Deck-AA1. Other than A4 paper cannot be loaded horizontally.
• For more information on the size change plate, see "Changing the Paper Size for the Paper
Deck-AA1," on p. 7-21.
• Hot air that is blown by the fan may warm the inner size change plate of the Paper Deck-AA1.
• If there are instructions on the package of paper about which side of the paper to load, follow
those instructions.
• When paper is loaded in the paper deck, the side facing up is the one printed on.
• If problems occur, such as poor print quality or paper jams, try turning the paper stack over, and
reload it.
• For more information on the print direction of preprinted paper (paper which has logos or
patterns already printed on it), see "Relationship between Original Orientation and Preprinted
Paper Output Chart," on p. 9-21.
2 ).
2 ) at a time. If
Paper Deck-AA1 (Optional)
) on the
7
7-19