Canon imagePRESS C1+ Reference Manual page 146

a Top Cover of the Finisher
Open this cover to remove jammed paper. (See "Inside the
Top Cover of the Finisher-AA1/Saddle Finisher-AA2
(Optional)," on p. 8-40.)
b Top Cover of the Punch Unit
Open this cover to remove jammed paper. (See "Punch
Unit-L1/N1/P1 (Optional)," on p. 8-55.)
c Front Cover of the Punch Waste Tray
Open this cover to remove punch waste or to remove
jammed paper. (For instructions on removing punch waste
see "Removing Punch Waste," on p. 7-39. For instructions
on clearing a paper jam, see "Punch Unit-L1/N1/P1
(Optional)," on p. 8-55.)
d Front Cover of the Finisher-AA1
Open this cover to replace the staple cartridge in the
stapler unit, or to clear a staple jam. (For instructions on
3
replacing the staple cartridge, see "Replacing the Staple
Cartridge in the Stapler Unit," on p. 7-32. For instructions
on clearing a staple jam, see "Finisher-AA1/Saddle
Finisher-AA2 (Optional)," on p. 8-58.)
e Front Cover of the Saddle Finisher-AA2
Open this cover to replace the staple cartridge, remove
jammed paper, or clear a staple jam in the stapler unit and
saddle stitcher unit. (For instructions on replacing the staple
cartridge in the stapler unit, see "Replacing the Staple
Cartridge in the Stapler Unit," on p. 7-32. For instructions
on replacing the staple cartridge in the saddle stitcher unit,
see "Replacing the Staple Cartridge in the Saddle Stitcher
Unit," on p. 7-36. For instructions on clearing a paper jam,
see "Inside the Front Cover of the Saddle Finisher-AA2
(Optional)," on p. 8-48, and "Saddle Stitcher Unit
(Optional)," on p. 8-51. For instructions on clearing a staple
jam in the stapler unit, see "Finisher-AA1/Saddle
Finisher-AA2 (Optional)," on p. 8-58. For instructions on
clearing a staple jam in the saddle stitcher unit, see "Saddle
Stitcher Unit (Optional)," on p. 8-61.)
3-16
Finisher-AA1/Saddle Finisher-AA2/Punch Unit-L1/N1/P1
f Booklet Tray (Saddle Finisher-AA2 Only)
Prints that are saddle stitched are output to this tray.
g Booklet Tray Guide (Saddle Finisher-AA2 Only)
Set this guide to match the size of the output paper. (See
"Finishing Modes," on p. 3-17.)
h Output Tray C
Prints are output to this tray. You can set the Tray
Designation mode to designate this tray for outputting prints
when using certain functions. (See "Output Tray
Designation," on p. 4-40.)
i Output Tray B
Prints are output to this tray. You can set the Tray
Designation mode to designate this tray for outputting prints
when using certain functions. (See "Output Tray
Designation," on p. 4-40.)
j Output Tray A
Prints are output to this tray. You can set the Tray
Designation mode to designate this tray for outputting prints
when using certain functions. (See "Output Tray
Designation," on p. 4-40.)