Canon imagePRESS C1+ Reference Manual page 424

10
6
11
12
13
6-140
Registering/Editing Custom Paper Types
Press [-] or [+] for <Back Side> to input the number of pixels to shift
the image.
Input the value from the test print paper.
Following the example in step 9, input [-6] for <Back Side>.
[+]: Press when the centre line of the register mark is located outside the edge of the test
print (the centre line of the register mark is NOT printed). The image is shifted the number
of pixels entered right the feeding direction of the paper.
[-]: Press when the centre line of the register mark is located inside of the edge of the test
print. The image is shifted the number of pixels entered left the feeding direction of the
paper.
Press [OK].
Perform the test print again, and check the location of the image.
Repeat steps 6 to 11 until the centre line of the register mark aligns with the left edge of the
paper.
IMPORTANT
When you open the [Image Location Adjustment] screen again after you close that screen by
pressing [OK], the values on screen are returned to [0]. Nevertheless the adjusted value is
effective. If you repeat steps, read off the value of register marks from new test print and input the
new value.
Press [Done].