Limiting Functions - Canon imagePRESS C1+ Reference Manual

Limiting Functions

If a problem frequently occurs when using the Finishing modes, such as Offset Collate and
Staple, you can temporarily limit the use of these finishing modes by setting Limited Functions
Mode to 'On'.
In addition, when the Service Call Message screen appears indicating a finishing mode
malfunction and you temporally set the Limited Functions Mode to clear the Service Call
Message screen, you can deactivate the Limited Functions Mode by setting this mode to 'Off'
from the Additional Functions screen. However, after the Limited Functions Mode is
deactivated, the Service Call Message screen may appear again, unless the cause of the
malfunction is cleared. (See "Setting the Limited Functions Mode from the Service Call
Message Screen," on p. 8-87.)
NOTE
[Limited Functions Mode] is displayed only if an optional finisher is attached.
1
Press
2
Select [On] or [Off] ➞ press [OK].
NOTE
The Limited Functions Mode is enabled only after you restart the machine (the main power is
turned OFF, and then back ON). For instructions on restarting (turning the main power OFF, and
then back ON) the machine, see "Main Power and Control Panel Power," on p. 1-18.
➞ [Common Settings] ➞ [Limited Functions Mode].
Specifying Common Settings
4
4-61