13.7 Light Sensor module replacement
W
ARNING
prior to start with this procedure.
Preparation
Light processor side cover of the projector must be removed before starting the light sensor module replacement..
Necessary tools
•
7mm flat screwdriver.
•
T10 Torx driver.
How to replace
1. Disconnect the light sensor cable (reference 1 image 13-19).
2
1
Image 13-19
2. Turn out both screws (reference 2 image 13-19) and take off the light sensor module.
3. Place a new module on the light pipe sockets and drive in both fixation screws (reference 2 image 13-19).
4. Plug in the cable into the light sensor module socket (reference 1 image 13-19).
R5905312 HDF W SERIES 24/01/2013
:
Disconnect the power cord from the projector and wait a few minutes (to discharge the capacitors)
2
13. HDF Light Processor
205