Barco HDF W Series Service Manual page 43

Code 2033: "LPS failure fan 2" (Error)
Situation
One of the two LPS fans fails.
Possible reasons: bad fan, not
connected, fan tachometer not
working, ...
If this failure was detected during
the startup of the LPS module then
the lamp can not be ignited. If this
failure occurs during an event then
the event can continue until the lamp
is switched off.
Code 2034: "LPS failure pfc driver" (Error)
Situation
Malfunction of one of the LPS
modules
Code 2035: "LPS failure power stage driver" (Error)
Situation
Malfunction of one of the LPS
modules
Code 6000: "Board id: input 1 unknown format" (Warning)
Situation
Old projector software installed. The
ID parameters of the input board
are written in a format which is not
known by the projector software.
Input board has invalid firmware.
Corrupt projector software.
Code 6001: "Board id: input 1 unknown module type" (Warning)
Situation
The input board inserted in this slot
is not supported by the software of
the projector.
The installed input board is not
supported by the projector.
Code 6002: "Board id: input 1 empty" (Info)
Situation
No input board present in this slot.
Code 6003: "Board id: input 1 read error" (Error)
Situation
Malfunction input board. The
projector can not read from the
installed input board.
Malfunction I²C communication on
the PMP board. Other input boards,
the Display board, the WARP module
and the Input & Communication unit
also have "Board id read errors".
R5905312 HDF W SERIES 24/01/2013
Solution
Replace one or both LPS modules. See "Lamp Power Supply", page 169.
Solution
Replace one or both LPS modules. See "Lamp Power Supply", page 169.
Solution
Replace one or both LPS modules. See "Lamp Power Supply", page 169.
Solution
Check if the version of the installed projector software is the latest available version. The
latest version can be downloaded from https://my.barco.com.
Replace the input board.
Reinstall the latest projector software.
Solution
Check if the version of the installed projector software is the latest available version. The
latest version can be downloaded from https://my.barco.com. To support a new type of
input board most likely requires an update of the projector software.
Replace the input board with a type that is supported by the projector.
Solution
If desired, insert one of the supported input boards.
Solution
Replace the input board.
Remove/disconnect the other boards from the I²C communication line one by one and
check if this error remains. Replace the board which makes this error goes away. If none
of the boards is the cause of this error, replace the PMP board. See chapter XXXX, to
see which boards are connected to the same internal communication line.
5. Troubleshooting
39