Removal Of The Input Cover - Barco HDF W Series Service Manual

6.4

Removal of the input cover

W
ARNING
Necessary tools
7 mm flat screw driver.
How to remove the input cover
1. Release the two captive screws at the top and bottom left side of the input cover, using a flat screw driver.
Image 6-7
Captive screws input cover
2. Remove the input cover from the projector as follows:
a) gently pull out the right bottom corner (A) of the input cover,
b) then gently pull out the right top corner (B) of the input cover,
c) then move the input cover away from the projector (C).
Image 6-8
Input cover removal
R5905312 HDF W SERIES 24/01/2013
:
This procedure may only be performed by qualified technical service personnel.
B
A
6. Removal and installation of the projector covers
C
101