15. Liquid cooling circuit
15.2 Filling the liquid cooling circuit
This procedure can only be used to fill an empty (drained) cooling circuit.
Necessary tools
•
Half a meter of plastic tube with male valved fitting.
•
Half a meter of plastic tube with female valved fitting.
•
Syringe connected with short tube with male valved fitting.
•
Bottle with cooling liquid.
•
Empty bottle with a volume of 1 liter.
•
Cloths.
How to fill the liquid cooling circuit ?
1. Interrupt the liquid cooling circuit by uncoupling the valved fitting at the heat exchanger.
Image 15-7
Uncouple heat exchanger
2. Couple a plastic tube, which contains a female valved fitting, to the exit side of the cooling circuit and lead the tube end to an
empty bottle.
244
2
1
R5905312 HDF W SERIES 24/01/2013