Pixel Mapping Processor Diagnostic Leds - Barco HDF W Series Service Manual

19.7 Pixel Mapping Processor Diagnostic LEDs

Location of the diagnostic LEDs
µC
1
2
3
Image 19-9
1 (not used, future expansion).
2 IR RECEIVED (green).
3 IR ACKNOWLEDGED (green).
4 SYNC INPUT1 (green).
5 SYNC INPUT2 (green).
6 SYNC INPUT3 (green).
7 SYNC INPUT4 + HEARTBEAT (green).
8 FIB FPGA CONFIG (red/yellow/green).
9 POWERGOOD STATUS (red/yellow:green).
10 (not used, future expansion).
11 RESET FPGA DONE (green).
12 ++12V OK (green).
13 LOCAL STBY OK (green).
14 PMP HEARTBEAT (green).
15 +12V OK (green).
16 LOCAL POWER OK (green).
17 INPUT FPGA CONFIG (green).
18 SCALER FPGA CONFIG (green).
19 FIB FPGA CONFIG (green).
20 SCALER HEARTBEAT (red)
21 SCALER SYSTEM RESET (yellow)
22 SCALER MEMORY READY (green)
23 SCALER HEARTBEAT (green)
View on the diagnostic LEDs
The Pixel Mapping Processor is located inside the Input & Communication unit. None of the LEDs are visible without opening the
projector. To view the diagnostic LEDs the Input & Communication unit has to be placed in the service position as illustrated below
(moved forward and tilted). The LEDs are then visible through the grid at the sides of the Input & Communication unit.
C
AUTION
tilted in it's service position. This to minimize the risk of exceeding the maximum permitted internal temper-
ature limit due to insufficient airflow.
R5905312 HDF W SERIES 24/01/2013
4 5 6 7
13 15 17 19
PMP
12 14 16 18
:
Only operate the projector for a few minutes while the Input & Communication unit is moved and
19. Board Diagnostic LED's
FIB
20 21 22 23
8 9 10 11
319