Installation Of The Wifi Module On The Communication Module - Barco HDF W Series Service Manual

10. Card Cage

10.7 Installation of the WIFI module on the Communication module

After the installation, the WIFI module needs to be configured. See the installation manual of the projector for
detailed instructions.
This procedure assumes that the Input & Communication Unit is removed from its compartment.
How to install the WIFI module?
1. Remove the Communication module from the Input & Communication Unit. See "Removal of an input module", page 146.
2. Remove the drive fastener (reference 1, image 10-9) from the front side of the Communication module.
1
Image 10-9
3. Position the 4 plastic spacers (reference 2, image 10-10) on the holes of the WIFI module.
4. Position the WIFI module (reference 3, image 10-10) on the spacers.
5. Install the screws (reference 4, image 10-10) and secure by tightening the nuts (reference 5, image 10-11) on the backside of
the Communication board.
2
2
Image 10-10
150
4
2
4
2
3
R5905312 HDF W SERIES 24/01/2013
4
4