Installation Of The Lamp Cover - Barco HDF W Series Service Manual

6. Removal and installation of the projector covers
6.7

Installation of the lamp cover

W
ARNING
Necessary tools
7 mm flat screw driver.
How to install the lamp cover
1. Install the lamp cover of the projector as follows:
a) Bring the lamp cover towards its final position (A),
b) then gently push the locking stud at the left top corner (B) into its receiver,
c) then gently push the locking stud at the left bottom corner (C) into its receiver.
A
Image 6-14
Lamp cover installaion
2. Secure the lamp cover by locking the two captive screws at the right side of the lamp cover.
Image 6-15
Captive screw locking
104
:
This procedure may only be performed by qualified technical service personnel.
B
C
R5905312 HDF W SERIES 24/01/2013