Barco HDF W Series Service Manual page 89

Situation
Corrupt firmware/software.
Malfunction Motor Control Board.
Code 8105: "Vertical lens shift end of range" (Error)
This error code is probably preceded by the warning code 8104: "Vertical lens shift end of range". The same troubleshooting table
can be applied to.
Code 8106: "Lens focus end of range" (Warning)
Situation
The lens focus has reached the end
of range.
Code 8107: "Lens focus end of range" (Error)
This error code is probably preceded by the warning code 8106: "Lens focus end of range". The same troubleshooting table can be
applied to.
Code 8108: "Lens zoom end of range" (Warning)
Situation
The lens zoom has reached the end
of range.
Code 8109: "Lens zoom end of range" (Error)
This error code is probably preceded by the warning code 8108: "Lens zoom end of range". The same troubleshooting table can be
applied to.
Code 8110: "Shutter time out" (Warning)
Situation
Wire unit disconnected.
Malfunction shutter motor.
Code 8111: "Shutter time out" (Error)
This error code is probably preceded by the warning code 8110: "Shutter time out". The same troubleshooting table can be applied
to.
Code 8116: "Vertical lens shift driver" (Warning)
Situation
The LED "ERROR CH2" on the
Motor Control Board lit up indicating
that there is a problem with the
vertical shift of the lens. See also
"Motor Control Board Diagnostic
LEDs", page 310.
Code 8117: "Vertical lens shift driver" (Error)
This error code is probably preceded by the warning code 8116: "Vertical lens shift driver". The same troubleshooting table can be
applied to.
R5905312 HDF W SERIES 24/01/2013
Solution
Reload the latest firmware and software version of the Motor Control Board.
Check the diagnostic LEDs of the Motor Control Board. Replace the Motor Control Board
if necessary. See "Replacing the motor control board (MCB)", page 283.
Solution
1. If unexpected, calibrate the lens. See installation manual of the HDF projector.
2. Ensure if the throw ratio of the lens is suitable for the projection distance. If not,
install a suitable lens.
Solution
1. If unexpected, calibrate the lens. See installation manual of the HDF projector.
2. Ensure if the throw ratio of the lens is suitable for the projection distance. If not,
install a suitable lens.
Solution
1. Check if the yellow wire unit from the shutter assembly is connected with the Motor
Control Board.
2. Check if the yellow wire unit is connected with the shutter assembly.
Replace the shutter assembly.
Solution
Check if:
• the wire unit of the stepper motor for vertical shift is connected.
• the wire unit of the stepper motor for vertical shift is not damaged (causing a open
circuit or short circuit).
• the stepper motor for vertical shift is not malfunctioning. If so, replace the stepper
motor. See "Replacement of the Vertical Shift stepper motor", page 234.
5. Troubleshooting
85