Removal Of The Lamp Cover - Barco HDF W Series Service Manual

6. Removal and installation of the projector covers
6.3

Removal of the lamp cover

W
ARNING
Necessary tools
7 mm flat screw driver.
How to remove the lamp cover
1. Release the two captive screws at the top and bottom right side of the lamp cover, using a flat screw driver.
Image 6-5
Captive screws, unlocking
2. Remove the lamp cover from the projector as follows:
a) gently pull out the left bottom corner (A) of the lamp cover,
b) then gently pull out the left top corner (B) of the lamp cover,
c) then move the lamp cover away from the projector (C).
B
A
Image 6-6
Lamp cover removal
100
:
This procedure may only be performed by qualified technical service personnel.
C
R5905312 HDF W SERIES 24/01/2013