Barco HDF W Series Service Manual page 100

5. Troubleshooting
Code 100055: "Init dvi adc failed, input 1" (Error)
Situation
Internal projector software error.
Code 100056: "Init dvi adc failed, input 3" (Error)
Situation
Internal projector software error.
Code 100057: "Init dvi firmware failed, input 2" (Error)
Situation
Internal projector software error.
Code 100058: "Init dvi firmware failed, input 4" (Error)
Situation
Internal projector software error.
Code 100059: "Init dvi settings failed, input 2" (Error)
Situation
Internal projector software error.
Code 100060: "Init dvi settings failed, input 4" (Error)
Situation
Internal projector software error.
Code 103000: "Storage: successful restoring" (Info)
Situation
The projector settings were
successfully stored in the backup
device.
Code 103001: "Storage: successful restoring with fall back mgt file" (Warning)
Situation
The projector settings were
successfully restored from in the
backup device after running the
recovery procedure.
Code 103002: "Storage: unsuccessful restoring" (Error)
Situation
The projector was not able to restore
the projector settings successfully
from the backup device.
Code 103003: "Storage: restoring without any preceding storing" (Info)
Situation
No data found in memory of backup
device.
96
Solution
First solve error/warning messages with ID number below 100000. If problem remains,
contact Barco.
Solution
First solve error/warning messages with ID number below 100000. If problem remains,
contact Barco.
Solution
First solve error/warning messages with ID number below 100000. If problem remains,
contact Barco.
Solution
First solve error/warning messages with ID number below 100000. If problem remains,
contact Barco.
Solution
First solve error/warning messages with ID number below 100000. If problem remains,
contact Barco.
Solution
First solve error/warning messages with ID number below 100000. If problem remains,
contact Barco.
Solution
No actions required.
Solution
No actions required.
Solution
The projector will still be operational. But if the Input & Communication unit has to be
replaced then the projector settings will be lost and needs to be manually uploaded. Note
this can only be done at factory or by qualified Barco service technicians.
To solve this issue save the projector Custom Settings and reboot the projector. If this
error persists, contact Barco for further actions.
Solution
No actions required. Projector will update data automatically.
R5905312 HDF W SERIES 24/01/2013