Installation Of The Side Cover - Barco HDF W Series Service Manual

6.6

Installation of the side cover

W
ARNING
Necessary tools
7 mm flat screw driver.
How to install the side cover
1. Check if the bottom and top filters are present.
2. Check the pressure indicated on the internal manometer of the liquid cooling circuit. This pressure should be between 0,5 and 1
bar. If the pressure is out of range, inform the responsible and qualified technician, so he may take necessary corrective action.
Image 6-11
3. Install the side cover of the projector doing the following:
a) Bring the side cover towards its final position (A),
b) then gently push the locking studs of the top corners (B) into their receivers,
c) then gently push the locking studs of the bottom corners (C) into their receivers.
Image 6-12
Mount side cover
4. Secure the side cover by locking the captive screw in the middle at the bottom of the side cover.
Image 6-13
Fixate captive screw
R5905312 HDF W SERIES 24/01/2013
:
This procedure may only be performed by qualified technical service personnel.
6. Removal and installation of the projector covers
103