Replacement Of The Smps Board - Barco HDF W Series Service Manual

10. Card Cage

10.16 Replacement of the SMPS board

W
ARNING
the cover of the SMPS compartment.
Necessary tools
7mm nut driver or flat screw driver.
How to replace the SMPS board?
1. Release the 4 retaining screws (reference 1 to 4) off the cover of the SMPS compartment .
Image 10-37
2. Remove the cover of the SMPS compartment.
Image 10-38
3. Pull out the SMPS board 3 or 4 centimeters out of its compartment and disconnect the following connectors:
- Mains input (reference 1 )
- Ground wire (reference 2)
- Control connector (blue wires) (reference 3)
- Power out connector (black wires) (reference 4)
1 2
Image 10-39
4. Pull the SMPS board completely out of its compartment.
166
:
Ensure that the projector is switched off and disconnected from the power net prior to remove
1
4
3 4
2
3
R5905312 HDF W SERIES 24/01/2013