8. LAMP AND LAMP HOUSE
About this chapter
This chapter the Lamp House and how to replace the xenon lamp in the Lamp House. Also included are the procedure to reset the
lamp parameters, which is required after a xenon lamp replacement, and the procedure to realign the lamp in its reflector for optimal
performance.
W
ARNING
XENON LAMP HANDLING OR SERVICE. ONLY TRAINED AND QUALIFIED TECHNICAL SERVICE PERSONNEL
ARE ALLOWED TO HANDLE THE XENON LAMP.
C
AUTION
of the bulb increases the pressure to a level at which the bulb may explode if not handled in strict accordance
to the manufacturer's instructions. The bulb is stable at room temperature, but may still explode if dropped or
otherwise mishandled. Whenever the lamp house, containing a xenon lamp, has to be dismantled or whenever
the protective container or cloth has to be removed from the xenon lamp, authorized protective clothing MUST
be worn!
W
ARNING
W
ARNING
W
ARNING
Overview
•
Introduction HDF Lamp & Lamp House
•
Removal of the lamp house
•
Installation of the lamp house
•
Removing the xenon lamp from the lamp house
•
Installing the xenon lamp in the lamp house
•
Resetting the lamp parameters
•
Realignment of the lamp in its reflector
•
Cleaning the UV blocker of the Lamp House
•
Cleaning the Reflector of the Lamp House
•
Lamp info module replacement
R5905312 HDF W SERIES 24/01/2013
:
DO NOT PERMIT UNAUTHORIZED PERSONNEL TO PERFORM OR ATTEMPT ANY PHASE OF
:
Xenon compact arc lamps are highly pressurized. When ignited, the normal operating temperature
:
Always wear face protection (full face shield) when handling xenon lamps.
:
Always wear protective clothing (welder's jacket) when handling xenon lamps.
:
Always wear clean leather gloves with wrist protectors when handling xenon lamps.
8. Lamp and lamp house
117