Removing The Xenon Lamp From The Lamp House - Barco HDF W Series Service Manual

8.4

Removing the xenon lamp from the lamp house

W
ARNING
XENON LAMP HANDLING OR SERVICE. ONLY TRAINED AND QUALIFIED TECHNICAL SERVICE PERSONNEL
ARE ALLOWED TO HANDLE THE XENON LAMP.
W
ARNING
C
AUTION
of the bulb increases the pressure to a level at which the bulb may explode if not handled in strict accordance
to the manufacturer's instructions. The bulb is stable at room temperature, but may still explode if dropped or
otherwise mishandled. Whenever the lamp house, containing a xenon lamp, has to be dismantled or whenever
the protective container or cloth has to be removed from the xenon lamp, authorized protective clothing MUST
be worn!
W
ARNING
W
ARNING
W
ARNING
Necessary tools
• Flat blade screw driver.
• 5 mm Allen wrench.
• 17 mm open-end wrench (2 pieces).
• Lamp protective container or protective cloth with two binders.
How to remove the xenon lamp
1. Release the xenon lamp from its socket by removing the hexagon socket head cap screw and washer as illustrated. Use a 5 mm
Allen wrench.
Image 8-7
Lamp fixation screw
2. Remove the Lamp House side cover by releasing the two retaining thumbscrews as illustrated.
R5905312 HDF W SERIES 24/01/2013
:
DO NOT PERMIT UNAUTHORIZED PERSONNEL TO PERFORM OR ATTEMPT ANY PHASE OF
:
This procedure may only be performed by qualified technical service personnel.
:
Xenon compact arc lamps are highly pressurized. When ignited, the normal operating temperature
:
Always wear face protection (full face shield) when handling xenon lamps.
:
Always wear protective clothing (welder's jacket) when handling xenon lamps.
:
Always wear clean leather gloves with wrist protectors when handling xenon lamps.
8. Lamp and lamp house
123