Barco HDF W Series Service Manual page 45

Code 6011: "Board id: input 2 write error" (Error)
Situation
Malfunction input board. The
projector can not write to the
installed input board.
Malfunction I²C communication on
the PMP board. Other input boards,
the Display board, the WARP module
and the Input & Communication unit
also have "Board id read errors".
Code 6012: "Board id: input 2 not calibrated" (Warning)
Situation
The installed input board has no
calibration values stored. The
projector will use default calibration
values for this input board.
Code 6013: "Board id: input 2 type on wrong location" (Info)
Situation
Board type data found on unusual
memory location
Code 6014: "Board id: input 3 unknown format" (Warning)
Situation
Old projector software installed. The
ID parameters of the input board
are written in a format which is not
known by the projector software.
Input board has invalid firmware.
Corrupt projector software.
Code 6015: "Board id: input 3 unknown module type" (Warning)
Situation
The input board inserted in this slot
is not supported by the software of
the projector.
The installed input board is not
supported by the projector.
Code 6016: "Board id: input 3 empty" (Info)
Situation
No input board present in this slot.
Code 6017: "Board id: input 3 read error" (Error)
Situation
Malfunction input board. The
projector can not read from the
installed input board.
Malfunction I²C communication on
the PMP board. Other input boards,
the Display board, the WARP module
and the Input & Communication unit
also have "Board id read errors".
R5905312 HDF W SERIES 24/01/2013
Solution
Replace the input board.
Remove/disconnect the other boards from the I²C communication line one by one and
check if this error remains. Replace the board which makes this error goes away. If none
of the boards is the cause of this error, replace the PMP board. See chapter XXXX, to
see which boards are connected to the same internal communication line.
Solution
No actions required. Parameters can be adjusted for the Analog Video applied on the
DVI connector. See projector's user guide.
Solution
No further action needed. Board will operate normally.
Solution
Check if the version of the installed projector software is the latest available version. The
latest version can be downloaded from https://my.barco.com.
Replace the input board.
Reinstall the latest projector software.
Solution
Check if the version of the installed projector software is the latest available version. The
latest version can be downloaded from https://my.barco.com. To support a new type of
input board most likely requires an update of the projector software.
Replace the input board with a type that is supported by the projector.
Solution
If desired, insert one of the supported input boards.
Solution
Replace the input board.
Remove/disconnect the other boards from the I²C communication line one by one and
check if this error remains. Replace the board which makes this error goes away. If none
of the boards is the cause of this error, replace the PMP board.
5. Troubleshooting
41