Hdf Light Processor - Barco HDF W Series Service Manual

13. HDF LIGHT PROCESSOR

About this chapter
This chapter gives a brief introduction of the Light processor assembly. Futhermore this chapter includes the replacement procedure
of the whole Light Processor.
W
ARNING
C
AUTION
away all dust on the outside of the Light Processor before entering the projector into the dust free area.
C
AUTION
sensitive parts.
C
AUTION
Overview
• Introduction HDF Light Processor
• Diagnostic
• Removing the Light Processor
• Installing the Light Processor
• Replacement of the shutter
• Cleaning the Prism exit side
• Light Sensor module replacement
• Adjusting the Fold Mirror
• High Contrast plate replacement
• Convergence controls
• Converging the red pattern onto the blue pattern
• Converging the green pattern onto the blue pattern
R5905312 HDF W SERIES 24/01/2013
:
The procedures below may only be performed by trained and qualified technicians.
:
All servicing to the Light Processor has to be done in a dust free area. Use compressed air to blow
:
Wear a wrist band which is connected to the ground while handling the electrostatic discharge
:
Remove the projector lens before removing the Light Processor.
13. HDF Light Processor
189