Connecting A Pc/Ethernet; Connecting The Mouse; Lpreparations; Raising The Camera Head And Light Arms - Barco R9840700 Quick Reference

Connecting a PC/Ethernet

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Before connection, be sure to turn the power to this unit and the device to be connected off.
When connecting to a network, first consult the administrator of the network.
For information on network settings, see "Connecting to a Network". (
Rear of this unit
10Base-T REMOTE
Commercially
available RS-232C
Commercially
available cable
Ethernet cable
to the Ethernet
to the RS-232C
connector connector
PC
: Signal flow

Connecting the Mouse

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Connect the mouse with the arrow mark of the mouse cable facing upward.
14
**BARCO 012-017(E) 14-15
CONNECTIONS
p.32)
Turn off the
power.
Using a screwdriver, tighten the screws of the
REMOTE connector.
Screwdriver
Note
[ The connection to the REMOTE connector is
required only when this unit is controlled with
RS-232C from a PC. For the RS-232C com-
mands, consult your dealer.
Mouse (supplied)
PREPARATIONS
When connections are completed, perform the following preparations before shooting images.

Raising the Camera Head and Light Arms

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
While holding the stopper
1
pressed, raise the camera
arm until it stands vertically.
Grip the camera arm when raising the camera
head.
Do NOT raise the camera head by grasping it.
Stopper
Raise it until it passes the
shooting position.
Raise the light stands and
2
turn the fluorescent lamps
toward the document stage.
Raise the left stand first.
Then, raise the right stand.
Do NOT forcibly rotate the
arms past their limits.
2000.7.18, 8:18 PM
Adjust the position and angle
3
of the camera head.
1
Return the camera arm to
the shooting position (do
NOT press the stopper).
When the camera arm is brought to the
shooting position, it locks in place.
2
Extend the camera arm.
When the camera arm is fully extended, it
locks in place.
Note
[ Once you heard a clicking sound, do
NOT attempt to extend the arm any fur-
ther. Doing so may damage the arm.
3
Turn the camera head to-
wards the document stage.
15
Continue