Danfoss VLT AutomationDrive FC 300 Programming Manual page 157

Parameter Descriptions
3.17.6 16-9* Diagnosis Read-Outs
NOTE
When using MCT 10 Set-up Software, the read-out
parameters can only be read online, i.e. as the actual
status. This means that the status is not stored in the MCT
10 Set-up Software file.
16-90 Alarm Word
Range: Function:
0 [0 - 4294967295 ] View the alarm word sent via the serial
*
communication port in hex code.
16-91 Alarm Word 2
Range: Function:
0 [0 - 4294967295 ] View the alarm word sent via the serial
*
communication port in hex code.
16-92 Warning Word
Range: Function:
0 [0 - 4294967295 ] View the warning word sent via the
*
serial communication port in hex code.
16-93 Warning Word 2
Range: Function:
0 [0 - 4294967295 ] View the warning word sent via the
*
serial communication port in hex code.
16-94 Ext. Status Word
Range: Function:
0 [0 - 4294967295 ] Returns the extended warning word sent
*
via the serial communication port in hex
code.
®
VLT AutomationDrive Programming Guide
®
MG33MG02 - VLT is a registered Danfoss trademark
3 3
155