Danfoss VLT AutomationDrive FC 300 Programming Manual page 145

Parameter Descriptions
14-57 Inductance Output Filter
Range: Function:
NOTE
This is required for correct
compensation in Flux mode
(1-01 Motor Control Principle)
14-59 Actual Number of Inverter Units
Range: Function:
Size related [ 1 - 1 ] Set the actual number of power units.
*
3.15.6 14-7* Compatibility
The parameters in this group are for setting of compati-
bility for VLT 3000, VLT 5000 to FC 300.
14-72 VLT Alarm Word
Option: Function:
[0] 0 - 4294967295 Read out the alarm word corresponding to
VLT 5000.
14-73 VLT Warning Word
Option: Function:
[0] 0 - 4294967295 Read out the warning word corresponding
to VLT 5000.
14-74 Leg. Ext. Status Word
Range: Function:
0 [0 - 4294967295 ] Read out the ext. status word
*
corresponding to VLT 5000
3.15.7 14-8* Options
14-80 Option Supplied by External 24VDC
Option: Function:
[0] No Select [0] No to use the frequency converter's 24 V DC
supply.
®
VLT AutomationDrive Programming Guide
14-80 Option Supplied by External 24VDC
Option: Function:
[1] Yes Select [1] Yes if an external 24 V DC supply will be used
NOTE
This parameter is only changing function by performing a
power cycle.
14-88 Option Data Storage
Range:
0
14-89 Option Detection
Selects the behaviour of the frequency converter when a change
in the option configuration is detected.
Option:
[0] Protect Option
[1] Enable Option
14-90 Fault Level
Option:
[0] Off
[1] Warning
[2] Trip
[3] Trip Lock
®
MG33MG02 - VLT is a registered Danfoss trademark
to power the option. Inputs/Outputs will be galvanically
isolated from the drive when operated from an external
supply.
[0 - 65535 ]
*
Function:
Freezes the current settings and
Config. prevents unwanted changes when
missing or defective options are
detected.
Changes drive settings and is used
Change when modifying the system configu-
ration. This Parameter setting will
return to [0] Protect Option Config. after
an Option Change.
Function:
Use this parameter to customize Fault levels. Use
[0] Off with caution as it will ignore all Warnings &
Alarms for the chosen source.
3
Function:
143
3