Removing And Replacing The Graphics Mezzanine Assembly - HPE Synergy 480 Gen10 Maintenance And Service Manual

Item Description
4 Heatsink latch
5 Alignment post
1
Symbol also on the processor and frame.

Removing and replacing the graphics mezzanine assembly

Procedure
1. Power down the graphics expansion module.
2. Remove the graphics expansion module from the frame.
3. Place the graphics expansion module on a flat, level work surface.
4. Remove the access panel.
5. Remove the graphics expansion graphics mezzanine assembly.
6. If replacing the mezzanine support bracket, remove it.
Removal and replacement procedures
81