Ovp Setting - R&S NGL200 Series User Manual

®
R&S NGL200/NGM200
Example:
[SOURce:]CURRent:PROTection:TRIPped?
Queries the OCP state of the selected channel.
Example:
Usage:
[SOURce:]CURRent:PROTection:UNLink <arg0>
Unlink fuse linking from the other channel (Ch1 or Ch2).
See
Parameters for setting and query:
<arg0>
Example:
Usage:
[SOURce:]CURRent:PROTection[:STATe] <arg0>
Sets or queries the state for over current protection (OCP).
See
Parameters:
<arg0>
Example:

7.5.10 OVP Setting

The VOLTage:PROTection subsystem contains the commands for setting the over-
voltage protection parameters for the output channels. The default unit is V.
User Manual 1178.8736.02 ─ 05
INST OUT1;:CURRent:PROTection:LINK 2
Channel 2 is linked with channel 1
INST OUT1;:CURRent:PROTection:LINK?2
Returns 1 if channel 1 is linked with channel 2
See
See
CURR:PROT:TRIP?
Response 1, the OCP is tripped.
Response 0, the OCP is not tripped.
Query only
Example "Configuring fuses"
1 | 2
CURR:PROT:UNL 1
Fuse linking is unlinked from channel 1
Setting only
Example "Configuring fuses"
1 | 0
1
Activates the OCP state.
0
deactivates the OCP state.
CURR:PROT 1
Activates the OCP.
Example "Configuring fuses"
Example "Configuring fuses"
on page 119.
on page 119.
Remote Control Commands
Configuration Commands
on page 119.
on page 119.
122