Ocp Setting - R&S NGL200 Series User Manual

®
R&S NGL200/NGM200
SENSe:CURRent:RANGe[:UPPer] <arg0>
Sets the current range for measurement. There is a selection of 10 A, 1 A, 100 mA and
10 mA range.
Parameters:
<arg0>
Example:
SENSe:VOLTage:RANGe:AUTO <arg0>
Enables or disables auto range for voltage measurement accuracy.
Parameters:
<arg0>
Example:
SENSe:VOLTage:RANGe[:UPPer] <arg0>
Sets the voltage range for measurement. There is a selection of 20 V and 5 V range.
Parameters:
<arg0>
Example:

7.5.9 OCP Setting

The CURRent:PROTection subsystem contains the commands for overcurrent pro-
tection parameters such as activating fuses and setting fuse parameters of the output
channels. The default unit is A.
The delay function of the fuses takes effect when the corresponding channel is activa-
ted (Output On).
User Manual 1178.8736.02 ─ 05
SENS:CURR:RANG 10
Sets the instrument to the 10 A measurement accuracy.
Refers to datasheet for the measurement accuracy in the 10 A
range.
1
Enables auto range for voltage.
0
Disables auto range for voltage.
SENS:VOLT:RANG:AUTO 1
Enables auto range for voltage.
SENS:VOLT:RANG 20
Sets the instrument to the 20 V measurement accuracy.
Refers to datasheet for the measurement accuracy in the 20 V
range.
Remote Control Commands
Configuration Commands
118