System Settings Commands - R&S NGL200 Series User Manual

®
R&S NGL200/NGM200
*RCL <Number>
Recall
Loads the instrument settings from an internal memory identified by the specified num-
ber. The instrument settings can be stored to this memory using the command
with the associated number.

7.2 System Settings Commands

The SYSTem subsystem contains the commands for general functions, which do not
affect signal generation directly.
SYSTem:BEEPer:STATe
SYSTem:LOCal
SYSTem:REMote
SYSTem:RWLock
SYSTem:KEY:BRIGhtness
SYSTem:DATE
SYSTem:TIME
SYSTem:BEEPer:STATe <Mode>
SYSTem:BEEPer:STATe?
Sets or queries the beeper tone.
Parameters:
<Mode>
Example:
Example:
SYSTem:LOCal
Sets the system to front panel control. The front panel control is unlocked. If the front
panel control was locked with the SCPI command SYSTem:RWLock, the message box
of the locked front panel on the instrument display will be disappeared.
Usage:
User Manual 1178.8736.02 ─ 05
................................................................................................... 92
................................................................................................................92
............................................................................................................. 93
.............................................................................................................93
................................................................................................ 93
................................................................................................................ 93
................................................................................................................. 93
1 | 0
ON
OFF - Control beeper is deactivated.
OFF
ON - Control beeper is activated.
*RST: ON
SYSTem:BEEPer:STATe ON
The front panel control beeper is activated.
SYSTem:BEEPer:STATe?
Queries the state of the front panel control beeper. Returns "0"
for deactivated (OFF) and "1" for activated (ON) control beeper.
Setting only
Remote Control Commands
System Settings Commands
*SAV
92