Range/Dvm Setting - R&S NGL200 Series User Manual

®
R&S NGL200/NGM200

7.5.8 Range/DVM Setting

The DVM and range settings are available only with R&S NGM power supply series
equipped with R&S NM-K104 (P/N: 3643.9927.02).
The SOUR:VOLT:DVM contains commands for activating the DVM function.
The SENSE:CURR:RANG and SENSE:VOLT:RANG contains commands for setting the
voltage range and current range of the measurements.
All these commands require *OPC? at the end of the command execution.
[SOURce:]VOLTage:DVM[:STATe]
SENSe:CURRent:RANGe:AUTO
SENSe:CURRent:RANGe[:UPPer]
SENSe:VOLTage:RANGe:AUTO
SENSe:VOLTage:RANGe[:UPPer]
[SOURce:]VOLTage:DVM[:STATe] <arg0>
Enables or disables digital voltmeter measurements.
Parameters:
<arg0>
Example:
SENSe:CURRent:RANGe:AUTO <arg0>
Enables or disables auto range for current measurement accuracy.
Parameters:
<arg0>
Example:
User Manual 1178.8736.02 ─ 05
....................................................................................117
..................................................................................... 117
...................................................................................118
......................................................................................118
................................................................................... 118
1 | 0
1
Enables digital voltmeter measurement.
0
Disables digital voltmeter measurement.
VOLT:DVM 1
MEAS:VOLT? -> 1.000E+00
Enables and returns digital voltmeter measurement.
1
Enables auto range for current.
0
Disables auto range for current.
SENS:CURR:RANG:AUTO 1
Enables auto range for current.
Remote Control Commands
Configuration Commands
117